Automatic powder packaging machine maintenance

Contact us

Tell: +86-15375353919
Phone: +86-15375353919
E-mail: sales@koyopacker.com
Address: No.245,Ziyun Road,Economic and Technological Development Zone,Hefei,Anhui,China.

Automatic powder packaging machine maintenance

Post time:8th May 2021

 

In recent years, my country's powder packaging machine market has maintained rapid growth. According to market analysis, the main reason why the market has received such attention is that China's market sales share is taking up an increasing proportion of its global market share. This is a good development opportunity for powder packaging machine companies.  

 

At present, whether it is food or medicine, daily chemical industry. Powder packaging machines are widely used, and powder packaging machines are constantly improving themselves on the basis of the past, aiming at humanized operation, focusing on the perfect combination of product quality and appearance, and making great contributions to my country's powder packaging machines. 

 

After purchasing the powder packaging machine, you should also pay attention to its daily maintenance and maintenance to ensure the normal operation of the equipment and extend the service life of the equipment. Below, KOYO will analyze several issues that need to be paid attention to in the maintenance of the powder packaging machine:

1. Lubrication work

 

It is necessary to regularly add oil to the gear meshing part, the oil hole of the bearing with a seat, and the moving parts. Once every shift, the reducer is strictly prohibited to run without oil. When adding lubricating oil, be careful not to rotate the oil tank On the belt, in order to prevent slipping and loss of rotation or premature aging of the belt and damage.

 

2. Maintenance work

 

Before using the powder packaging machine, check the screws of each part, and there must be no looseness, otherwise, it will affect the normal operation of the whole machine. For the electrical parts, pay attention to waterproof, moisture-proof, anti-corrosion and rat-proof work. In order to ensure that the inside of the electric control box and the wiring terminals are clean to prevent electrical failure, after the shutdown, the two hot air heaters should be used in the open position to prevent the packaging materials from being burnt.

 

3. Cleaning work

 

After the equipment is shut down, the metering part should be cleaned in time, and the hot air device body should be cleaned frequently to ensure that the sealing lines of the packaged product are clear. The scattered materials should be cleaned up in time to facilitate the cleanness of the machine parts, so as to better extend its use During the life span, colleagues must also clean the dust in the electric control box frequently to prevent electrical failures such as short circuits or poor contacts.

 

Email to this supplier

*Name:

*Email:

*Content:


*Verification: